Smarthome 2486D User Manual download pdf (Page 20)

INSTEON KeypadLinc V2 Dimmer User’s Guide

HOW TO SET UP ON-LEVELS AND RAMP RATES

Setting the On-Level

1. Hold down KeypadLinc Dimmer’s On Button or Off Button to adjust the brightness of the controlled

light to the desired On-Level.

2. Press the SET Button at the bottom of the switch.

3. KeypadLinc Dimmer will flash the controlled light once to confirm the On-Level setting.

Setting the On-Level and Ramp Rates (Optional)

The On-Level is the brightness that the light you are controlling will go to when you turn it on. The On-

Level is adjustable from 3% to 100% brightness. The default is 100%.

The Ramp Rate sets the time it will take for the light you are controlling to go from OFF to the On-Level

brightness, or from the On-Level brightness to OFF. This time is adjustable from 0.1 to 9 seconds to

ramp between full-ON and full-OFF. The default is 0.1 second.

KeypadLinc Dimmer can store multiple On-Levels and Ramp Rates in its memory.

Local On-Level and Ramp Rate values apply when you tap the On Button or Off Button on KeypadLinc

Dimmer itself.

Remote-Controlled On-Level and Ramp Rate values apply when another INSTEON Controller tells

KeypadLinc Dimmer to turn on or turn off. KeypadLinc Dimmer stores separate On-Levels and Ramp

Rates for each button on each Controller that it is linked to. These On-Levels and Ramp Rates can all be

the same, or they can be different.

You establish an On-Level and Ramp Rate by first setting them up and then locking them in. Setting an

On-Level and setting a Ramp Rate are always done the same way, but locking them in is different,

depending on what you want the On-Level and Ramp Rates to apply to.

You can set up an On-Level or Ramp Rate in any order. When you do the lock-in, the currently-set On-

Level and Ramp Rate are locked in together.

CAUTION

If you hold the SET button for more than three seconds you may accidentally put KeypadLinc

Dimmer into linking mode (pressing and holding the SET button is an alternate way to activate

linking mode). If you find yourself in this situation, exit linking mode by simply pressing the ON

button once.

Page 20 of 38

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

No comments

Smarthome 2486D User Manual Page 20